ADIC SNC 5100 - Manual (Page 143)

Commands 135
6-00020-02
SNC 5100
hlthChkLevelGet
To display the current Health Check level, use the hlthChkLevelGet
command. The example below shows that the current level is 2.
SN60023 > hlthChkLevelGet
value = 2 = 0x02
SN60023 >
hlthChkLevelSet
To set the Health Check level, use the hlthChkLevelSet command. The
example below shows setting the level to 3.
SN60023 > hlthChkLevelSet 3
value = 0 = 0x0
SN60023 >
hlthChkNow
The hlthChkNow function causes the SNC 5100 to execute an immediate, level
4 Health Check. Results are displayed that will indicate which devices or
subsystems failed the check.
SN60023 > hlthChkNow
Health Check: Starting level 4 check
Health Check: Step 1 -- Checking System
Health Check: Step 2 -- Checking Interfaces
Health Check: Step 3 -- Checking Devices
Health Check: Step 4 -- Checking Device States
Health Check: Passed
value = 0 = 0x0
SN60023 >
host “ add ” , “ hostname ” , “ ipAddress ”
The host “ add ” command adds the named host to the host table and host file.
If the IP address is already assigned to a host, then the new name is added as an
alias for the host. The
host “ add ” command is invoked to add known hosts
and their IP addresses. Alias names are supported, allowing multiple names to
a single host.
The host utilities maintain a host file, nvfs:/mgnt/hosts , which is used