ADIC SNC 5100 - Manual (Page 169)

Commands 161
6-00020-02
SNC 5100
to determine the actual period (exception: if the
period is negotiated to 12, then 50ns. is used).
The offset indicates the REQ/ACK offset that
was negotiated. A zero in these fields indicates
that asynchronous transfer is in use.
Width The negotiated transfer width in bits, either 8 or
16.
scsiTermGet [channel]
The scsiTermGet command displays termination status information for the
specified channel. If no channel is specified, status information is displayed for
all SCSI channels.
SN60023 > scsiTermGet
SCSIbus Termination ------- ---------------
SCSI 1 Enabled – default
SCSI 2 Enabled
value = 0 = 0x0
SN60023 >
SN60023 > scsiTermGet 2
SCSIbus Termination ------- ---------------
SCSI 2 Enabled – default
value = 0 = 0x0
SN60023 >
scsiTermSet [channel],[termination]
The scsiTermSet command enables or disables the termination for the SCSI
Channel.
setFcFrameSize [channel],[size]
Set the frame size for a channel using the setFcFrameSize command.
Parameter Value Meaning
Channel Number 1 - 4 Selected Channel
Termination 0 Enable Termination
1 Disable Termination