ADIC SNC 5100 - Manual (Page 22)

SNC 5100
14 Hardware Product Description and Features
6-00020-02
The service port is used for local service and diagnostics when you use a
terminal session to access the shell interface.
The service port is configured at:
• 19,200 Baud
• 8 data bits
• No parity
• One stop-bit
• Hardware Flow Control or Xon/Xoff or other internally detected error
conditions
LED Indicators
The User panel of the SNC 5100 provides LEDs that indicate the status and
activity of the SNC 5100 and its interfaces.
Figure 4 LEDs
When the SNC 5100 is first turned on, some of the LEDs will be on and others
will flash while it is booting.
The following list briefly describes how to interpret the LED signals. See also
“POST Error Codes” on page 197.
FC 1-2
For each FC Channel, the LED will be OFF when the Channel is not
connected. It will be ON when the Channel is connected to a live Fibre
Channel device. It will flash when there is activity on the Channel.