Aiwa XR-H33MD - Manual (Page 24)

(3) Within 10 seconds, press ENTER again.
3 Press one of the function buttons and prepare the source to be recorded.
To record from a CD, press the CD button and load the CD(s). Then, select an track to be recorded first with the
, buttons or MULTI JOG control.
To record form an MD, press the MD button and insert an MD. Then, select a track to be recorded first with the
, buttons or MULTI JOG control.
To record from a radio broadcast, press the TUNER button and tune into a station.
To record from a connected source,
• To record from a source of equipment connected to DIGITAL IN terminal on the rear, press AUX/D-IN repeatedly
until "D-IN" appears in the display.
• To record from a source of equipment connected to AUX IN terminal on the rear, press AUX/D-IN repeatedly until
"AUX" appears in the display.
4 Press the
z z REC/REC MUTE button to start recording.
When the selected function is CD or MD, playback and recording start simultaneously.
To stop recording, press the
„ button.
To pause recording, press the button. (Applicable when the source is TUNER or AUX/D-IN.) To resume
recording, press again.
INSERTING BLANK SPACES
4-second blank spaces can be inserted at the desired point during recording. (Applicable when the source is TUNER
or AUX/D-IN.)
1 Press the
z z TAPE REC/REC MUTE button during recording or while in recording pause mode.
"TAPE REC " on the display flashes for 4 seconds and the tape runs without recording. After 4 seconds, the deck
enters the recording pause mode.
2 Press the
button to resume recording.
To insert a blank space of less than 4 seconds, press the
z z TAPE REC/REC MUTE button again while "TAPE
REC " is flashing.
To insert blank spaces of more than 4 seconds, after the deck enters recording pause mode, press the
z z TAPE
REC/REC MUTE button again. Each time the button is pressed, a 4-second blank space is added.
To erase a recording
1 Insert the tape to be erased into deck 2 and press the TAPE/DECK 1/2 button to display "TAPE 2".
2 Set the tape to the point where the erasure is to be started.
3 Press the
z z TAPE REC/REC MUTE button to start the erasure.
RECORDING (cont.) pg. 16
DUBBING A TAPE MANUALLY