Controller, Chassisname, Clearconfigurationwithdataloss – HP Scripting Toolkit for Windows 9.60 User Manual
Page 35: Licensekey, deletelicensekey, Preferredpathmode
•
QueueDepth
•
ReadCache
•
RebuildPriority
•
SSPState
•
SurfaceScanDelay
•
WriteCache
Controller
You must enter a value for this option because it identifies the controller that you want to configure:
•
All
—Configure all detected controllers in the system.
•
Slot [N][:M]
—Configure the internal controller in slot number N, or the external controller
at port M in slot N.
•
WWN [N]
—Configure the external controller that has the World Wide Name N.
•
SerialNumber [N]
—Configure the shared storage controller that has serial number N.
•
IOCabinet[N],IOBay[N],IOChassis[N],Slot[N],Cabinet[N],Cell[N]
—Configure
the controller in the Integrity server that has the slot path information defined by this sequence
of identifiers.
ChassisName
Enter the user-defined character string that identifies the controller. You can use any of the following
characters in the string:
a–z, A–Z, 0–9, !, @, #, *, (, ), ,, -, _, +, :, ., /, [space]
You do not need to use quotation marks around the string, but doing so allows the string to begin
with a space character. However, the string cannot end with a space character.
Currently, only shared-storage controllers such as the RA4x00, MSA1000, and Smart Array Cluster
Storage support the ChassisName option. The RA4x00 controller uses a 24-character string, while
other applicable controllers use a 20-character string.
ClearConfigurationWithDataLoss
This command is now deprecated.
The default value for this option is No. Clearing the configuration causes data loss because it
deletes all logical volumes and arrays on the controller. If you clear a configuration, you can write
commands later in the script file to create a new configuration from the liberated drive capacity.
LicenseKey, DeleteLicenseKey
These options enable you to enter a 25-character license key to activate or uninstall some controller
features. Hyphens can be entered, but are not required.
PreferredPathMode
The setting that you select for this option determines how the preferred I/O path to a particular
logical drive is set for a redundant array controller that is in an active/active configuration.
Using HPSSASCRIPTING
35