HP Scripting Toolkit for Windows 9.60 - Manual (Page 51)

Description Command-line argument
This argument sets the iLO configuration based on the
information in the XML input file named filename. -f
filename
This argument logs replies to the text log file named
filename. -l
filename
This argument writes the iLO configuration obtained from
the device to the XML output file named filename. -w
filename
This argument returns the host server name and serial
number. -get_hostinfo
This argument indicates to HPONCFG the minimum
firmware level that must be present in the management -m
device to execute the RIBCL script. If the minimum level is
not met, HPONCFG returns an error without performing
any additional actions.
This argument causes HPONCFG to configure the server
for optimized mouse handling. -mouse
NOTE: For a complete list of all command-line parameters, execute the /h utility.
HPONCFG return codes
Meaning Value
The script was sent successfully to the device. 0
The script could not be sent to the device. 1
If the script itself fails, errors are reported in the log file created by HPONCFG.
HPONCFG command file contents
HPONCFG can be used to perform the following tasks:
•
Obtain an entire configuration
•
Obtain a specific configuration
•
Set a configuration
Obtaining an entire configuration
HPONCFG can be used to obtain an entire configuration from iLO. In this case, the utility executes
from the command line without specification of an input file. The name of the output file is given
on the command line. For example:
hponcfg -w config.xml
In this example, the utility indicates that it obtained the data successfully and wrote it to the output
file as requested. The following is a typical example of the contents of the output file:
<HPONCFG VERSION = "1.1">
<!--- Generated 04/15/04 15:20:36 --->
<MOD_DIR_CONFIG>
<DIR_AUTHENTICATION_ENABLED VALUE = "N"/>
<DIR_LOCAL_USER_ACCT VALUE = "Y"/>
<DIR_SERVER_ADDRESS VALUE = ""/>
<DIR_SERVER_PORT VALUE = "25"/>
Using HPONCFG 51