HP Scripting Toolkit for Windows 9.60 - Manual (Page 49)

HPQLAREP command-line arguments
Description Command-line argument
This argument saves the HBA configuration to the filename. hpqlarep —s filename
This argument loads the HBA configuration to the filename. hpqlarep —l filename
Where filename has the following format:
Section for each HBA [HBA0]
Read-only variable WWID=11223344
Read-only variable HostAdapterBiosEnable=1
Read-only variable SelectBootEnable=1
Your input BootDeviceWWID=22334455
Your input and default LUN BootDeviceLUN[0]=1111
HPQLAREP return codes
Meaning Value
The command was completed successfully. 0
There was an invalid command line option. 1
There was a file open error. 2
There was an NVRAM checksum error. 3
There was an NVRAM data error. 4
There was no adapter found on this host. 5
There was an error retrieving the I/O address. 6
The WWID was invalid. 7
The LUN setting was invalid. 8
The EFI Enable Selective LUN setting was invalid. 9
The BIOS Enable setting was invalid. 10
The Selectable BIOS setting was invalid. 11
The EFI Selective login settings were invalid. 12
The EFI WWID (Boot Node Name) was invalid. 13
There was a Memory Allocation error. 14
The adapter has no VPD. 15
There was a failure reading the adapter VPD. 16
The adapter has no VPD. 17
VPD has bad checksum. 18
The adapter serial number is missing in the VPD. 19
Using HPQLAREP 49