HP LaserJet 5200 Printer series - Manual (Page 59)

5. Press or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
Auto continue
You can determine printer behavior when the system generates an auto-continuable error. ON is the
default setting.
● Select ON if you want an error message to appear for 10 seconds before the printer
automatically continues to print.
● Select OFF to pause printing any time an error message appears and until you press .
To set auto continue
1. Press Menu to open the menus.
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight SYSTEM SETUP, and then press .
4. Press to highlight AUTO CONTINUE, and then press .
5. Press or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
Cartridge low
The printer has two options for reporting that print-cartridge life is low: CONTINUE is the default value.
● Select CONTINUE to allow the printer to continue printing while a warning appears and until the
print cartridge is replaced.
● Select STOP if you want the printer to pause printing until you replace the used print cartridge
or press , which allows the printer to print while the warning appears.
To set supplies-low reporting
1. Press Menu to open the menus.
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight SYSTEM SETUP, and then press .
4. Press to highlight CARTRIDGE LOW, and then press .
5. Press or to select the appropriate setting, and then press .
6. Press Menu to exit the menu.
ENWW Changing printer-control-panel configuration settings 45