HP StorageWorks XP10000 Disk Array - Manual (Page 17)

1 Overview of LUN Manager
The XP12000/XP10000/SVS200 arrays integrate the following storage environments to provide
advanced storage solutions:
• Fibre Channel: Fibre Channel is a protocol that enables fast data transfers and can be used for
configuring a storage area network (SAN). To use an array as SAN storage, you should attach
host servers to the array's Fibre Channel ports.
• iSCSI: internet Small Computer System Interface (iSCSI) is a protocol that enables data transfers
between host computers and large-scale storage devices over an Internet Protocol (IP) network
and is suitable for data transfers between remote locations. To use an array as IP storage, you
should attach host servers to the array's iSCSI ports.
In an iSCSI environment, the array provides mutual user authentication between hosts and ports using
Challenge Handshake Authentication Protocol (CHAP).
NOTE:
• iSCSI environments that you create with LUN Manager support local connections (that is, hosts
in the same domain can communicate with each other), but neither support inter-domain
connections or external LAN connections.
• When configuring iSCSI environments, you must confirm the operating systems used to run hosts
in the IP network. You can configure iSCSI networks only when each host runs on the Windows
Server 2003, Windows 2000®, or HP-UX 11i operating system. However, user authentication is
not available on hosts running on HP-UX 11i.
• You can connect switching hubs to iSCSI ports, but cannot connect other network relay devices
to iSCSI ports.
• NAS: NAS is a type of storage device attached to a LAN. NAS contains an embedded operating
system and file system to enable file sharing by multi-platform host servers. To use an array as a
NAS storage, you should attach host servers to the array's NAS ports.
HP StorageWorks LUN Configuration and Security Manager XP user guide for the
XP12000/XP10000/SVS200
17