HP StorageWorks XP10000 Disk Array - Manual (Page 72)

NOTE:
If you are using a 2 Gbps HBA and switch, set the CHF port's transfer speed to 2 Gbps. If you
are using a 1 Gbps HBA and switch, set the CHF port's transfer speed to 1 Gbps. If the Auto
Negotiation setting is required, the linkup might be incorrect at server reboot. Check the channel
lamp. If it is blinking, remove and re-insert the cable to perform the signal synchronization
and linkup.
• Fibre Addr.: The text box on the left displays the selected port's address.
Use the list on the right to specify the selected port's address.
• Fabric: The text box on the left indicates whether a fabric switch is used. This option must be
set to ON if a fabric switch is used. This option must be set to OFF if a fabric switch is not used.
Use the list on the right to specify whether a fabric switch is used.
• Connection: The text box on the left indicates the topology. This text box can display FC-AL
or P-to-P (point-to-point).
Use the list on the right to specify the topology.
CAUTION:
Some fabric switches require you to specify the point-to-point topology. If your system uses a
fabric switch, check the fabric switch's documentation to determine whether the fabric switch
requires the point-to-point topology.
• Set: Applies settings in the Change Port Mode box to the Port table.
• Clear: Cancels settings in the Change Port Mode box.
• If you select an iSCSI channel adapter, this box displays items related to iSCSI ports and iSNS
servers (for more information, see iSCSI port and iSNS server settings ).
Figure 28 Change Port Mode box (iSCSI port and iSNS server)
• Select a Port: To change a port's settings, select the port from this list.
• IP Address: Selected port's IP address.
• Subnet Mask: Subnet mask.
• Gateway: Gateway address.
• Port Number: Port number.
• Keep Alive Timer: Keep-alive timer value. The unit is seconds.
• iSNS Server: Specifies whether to register information about the iSCSI port in the iSNS server.
• Enable: Registers the iSCSI port.
• Disable: Does not register the iSCSI port.
• IP Address of iSNS Server: iSNS server's IP address.
• Port Number of iSNS Server: iSNS server's TCP port number.
72 LUN Manager panes