HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 45)

Command line 45
interconnect-mac-table
Display interconnect module MAC table information.
Supported actions: help, show
Item Description
show interconnect-
mac-table
Display interconnect module MAC table information for the specified module.
Syntax
show interconnect-mac-table <ModuleID> [FilterBy]
Parameter
ModuleID (required) The ID of the module for which to display the MAC table. The ID is in the format
of <EnclosureID>:<BayNumber>.
Option
FilterBy (optional) The MAC table output can be filtered by property. The output filter syntax used is
Property=Value.
Examples
->show interconnect-mac-table enc0:1
Displays the module MAC table for the module in bay 1 of enclosure enc0
->show interconnect-mac-table enc0:1 Port=d6
Displays the module MAC table for the module in bay 1 of enclosure enc0 filtered
to show only addresses on port d6
->show interconnect-mac-table enc0:1 "MAC
Address"=00:26:55:58:89:9d
Displays the module MAC table for the module in bay 1 of enclosure enc0 filtered
on a single MAC address
iscsi-boot-param
Manage iSCSI boot parameters within a domain.
Supported actions: help, remove, set, show
Item Description
remove
iscsi-boot-param
Remove all iSCSI boot parameters configured on the specified iSCSI
connection.
Syntax
remove iscsi-boot-param <ConnectionID>
Parameter
ConnectionID
(required)
The ID of an existing iSCSI connection. The ID format is <ProfileName:Port>. To
retrieve the port number of the iSCSI connection, use the show profile
<ProfileName> command.
Example
->remove iscsi-boot-param MyProfile1:1
Removes boot parameters configured on connection 1 of MyProfile1
Item Description
set iscsi-boot-param Configure the basic iSCSI boot parameters on the specified iSCSI connection.
Syntax
set iscsi-boot-param <ConnectionID> [-maskSecret]
[-maskMutualSecret]
[BootOrder=<Primary|Secondary|Disabled|USE-BIOS>]
[LUN=<Logical Unit number>] [InitiatorName=<Initiator
name>] [InitiatorIP=<IP address>] [Mask=<Netmask>]