HP NonStop G-Series - Manual (Page 30)

Installation and Basic Management
HP NonStop AutoTMF Software User’s Guide—429952-014
2-8
Create the Mapping Database
When you create MapDB, the NonStop AutoTMF monitor process is started to manage
access to MapDB. See
CREATE MAPDB on page 6-52 for details about this
command.
When the monitor process is started, the following messages should be displayed by
the EMS distributor:
The monitor process is a fault-tolerant process-pair that has the process name $ZESC;
you should not have to restart it unless you intentionally stop it or cold load the system.
If you discover that the monitor process is not running, start it by using the command:
You may wish to configure the NonStop AutoTMF monitor process parameters, such
as priority and cpus. In particular, the monitor priority should be higher than all
application programs to avoid delays during process startup.
The section Monitor Process on page A-2 describes, in detail, how to configure and
determine the status of the Monitor process.
15:58 11MAY11 099,05,093 $ZESC 100 ESCMON starting Version
1.9.1 - 09JUN2011
15:58 11MAY11 099,05,093 $ZESC 149 ESCMON message
AutoTMF License Information
License is Valid
Expiration date: Oct 15 2011
Maximum logical processors 8
15:58 11MAY11 099,05,093 $ZESC 149 ESCMON message
AutoTMF Global Settings
AutoTMF ON
ATMFCommonTx ON
ATMFMaxTime 16 seconds
ATMFMaxUpdate 32
ATMFNowait OFF
ATMFIsolation Weak
ATMFTxHoldoff 0 seconds
ATMFAuditRename OFF
ATMFSkipNullRecs OFF
ATMFReadThruLock ON
ATMFAutoCommit 115 minutes
ATMFTXTimeout OFF (requires TMF 3.6)
ATMFAbendNoAudit ON
ATMFOptmzUnlocks OFF
ATMFSTOPonTMFErr OFF
ATMFMaxTX 100
ATMFNoWarnLongTx OFF
ATMFSeparateTx OFF
MaxMonitorOpens 512
DynamicTrace ON
SecureTrace ON
EMSCollector $0
15:58 11MAY11 099,05,093 $ZESC 101 ESCMON started Version
1.9.1 - 09JUN2011
15:58 11MAY11 099,05,093 $ZESC 112 ESCMON ATMFFILE table cached. Table
entry count = 2.
15:58 11MAY11 099,05,093 $ZESC 112 ESCMON ATMFPROG table cached. Table
entry count = 2.
15:58 11MAY11 099,05,093 $ZESC 104 ESCMON backup started, cpu 4
START MONITOR;