HP Designjet 2500.3500cp Printer series - Manual (Page 286)

Front-Panel Messages
Message Explanations and Actions
12-8
Load media to
check printheads The printer is telling you to load media so it can perform the printhead check.
Load media to proceed with printhead check.
Load sheet for
calibration The printer is ready to perform the accuracy calibration procedure, but media is not
present.
Load media to continue.
Lower lever Lower the lever at the right of the printer.
Lower lever
Remove media Lower the lever at the right of the printer and remove the media.
Lower window
to continue The window was opened while the printer was busy.
Close the window to continue.
Media too small You may have sent a print file that is too large for the media loaded; the print may be
clipped.
Press Cancel if the media is unsuitable, and reload with appropriate media.
Media too small for
calibration
→
The media you loaded for printhead alignment or a printhead check is too small. The
procedure has been cancelled. You may continue printing without calibrating the
printer, but the image quality is not assured.
Press
↓
to continue. If you want to complete the interrupted procedure, reload with
appropriate media (A3-size paper or larger, in landscape orientation) and redo the
procedure:
• Use Image quality / Printhead service / Align now for printhead alignment.
• Use Image quality / Printhead service / Printheads check / Now for a printhead
check.
MIO error
Communication
break The flow of data from the computer to the printer stopped prematurely (for example,
the computer may have been shut down before all data was sent).
Press Enter to clear the message from the front panel display.
MIO error
handshake You configured the modular interface incorrectly.
Press the Enter key to clear the message from the front panel. Check the handshake
settings in the printer’s front panel, in the hardware configuration, and in your
application software configuration to make sure they are compatible with one another.
Mispositioned
Reload roll The roll media is mispositioned.
Remove and reload the roll.
Message Explanation and Action