Changing the interface settings, Network, Parallel – HP Designjet 2500.3500cp Printer series User Manual
Page 192: To change the i/o time-out setting, Changing the interface settings 8-10, To change the i/o time-out setting 8-10
Reconfiguring Your Printer
Changing the Interface Settings
8-10
Changing the Interface Settings
Network
With a network interface (such as the HP JetDirect Print Server), refer to your
network interface documentation for advice on any front-panel configuration. The
front-panel menu is
I/O Setup / Modular / MIO
….
Parallel
With a parallel interface, no front-panel configuration is necessary.
To Change the I/O Time-out Setting
Some software applications do not write a file terminator at the end of a file. In this
case, the printer does not know when the file is complete and will wait for more
data until the end of the “I/O Time-out” period. By default, this period is 30
minutes. You can change the time-out setting in the front-panel menu to as little as
30 seconds.
I/O SETUP
Modular
Full menu mode only
MIO
I/O SETUP
I/O Time-out
Full menu mode only
Default: 30 min