HP Designjet 2500.3500cp Printer series - Manual (Page 85)

Working with Media
Changing the Core Tube on the Take Up Reel Accessory
3-35
Changing the Core Tube on the Take Up Reel Accessory
The Core tube on the Take Up Reel must be the same width as the media you are
using. To change the core perform the following procedure.
1 Slide open the spindle lock on the right hand side of the Take Up Reel.
2 Remove the Take Up Reel spindle from the printer as shown by pulling firmly on
each end of the spindle, A then B.
12'' / 305mm
C472358
A
B
12'' / 305mm
42' ' / 1 067 mm
+ 54' '/13 72m m = + 36' '/91 5m m
= + 50' '/12 70m m =
C472349d