HP Designjet 2500.3500cp Printer series - Manual (Page 95)

Working with Media
Drying time (With a Take Up Reel)
3-45
Automatic
This is the default setting. The printer (if necessary) will automatically adjust the
drying time depending on the following:
n Type of Media
n Print Mode
n Width of printing area
n Environmental conditions
CAUTION To avoid the printer adding drying time to prints operate the printer under the
following environmental conditions:
Manual
In this mode you can override the amount of time that the printer has calculated to
print your plot. The time shown in the front panel will be the amount of time that it
will take to reach the Core on the Take Up Reel.
NOTE:However there is a certain amount of time that the printer has to take to
process your job, if the amount of time that you have specified is less than this time
the printer will ignore your setting.
HP Media Type Width of printing
area
Max.% Relative
Humidity
Max. Temperature
0
C
High-gloss photo 24 inches or more 50 30
Semi-gloss photo 24 inches or more 50 30
Imaging film-backlit 24 inches or more 40 35