HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem User Manual

Page 150

Advertising
background image

Virtual Connect server profiles 150

<TargetIP>—Replace this parameter with a valid IPv4 address in dotted decimal notation. This is a

mandatory field.

<TargetTCPPort>—Replace this parameter with a decimal number ranging from 1 to 65535

(inclusive). This is an optional field. The default TCP port 3260 is assumed, if not specified.

<LUN>—This parameter is a hexadecimal representation of the Logical Unit Number of the boot device.

This is an optional field. If not provided, LUN 0 is assumed to be the boot LUN. It is an eight-byte
number, which should be specified as a hexadecimal number consisting of 16 digits, with an

appropriate number of 0s padded to the left, if required.

<TargetName>—Replace this parameter with a valid iSCSI target ‘iqn’ name of up to 223 characters.

This is a mandatory field.

<InitiatorName>—Replace this parameter with a valid iSCSI ‘iqn’ name of up to 223 characters.

This is an optional field. If not provided, the default Initiator name is used.

<HeaderDigest>—This is an optional field. Replace this parameter with either "E" or "D".

o

"E" denotes that the header digest is enabled.

o

"D" denotes that the header digest is disabled.

If not provided, Header Digest is disabled by default.

<DataDigest>—This is an optional field. Replace this parameter with either "E" or "D".

o

“E” denotes that the data digest is enabled.

o

“D” denotes that the data digest is disabled.

If not provided, Data Digest is disabled by default.

<AuthenticationType>—This is an optional field. If applicable, replace this parameter with “D”,

“E”, or “M”.

o

“D” denotes that authentication is disabled.

o

“E” denotes that one-way CHAP is enabled. The user name and secret used for one-way CHAP

must be specified by non-DHCP means.

o

“M” denotes that Mutual CHAP is enabled. The user name and passwords required for Mutual

CHAP authentication must be specified by non-DHCP means.

If not specified, this field defaults to authentication-disabled.

Examples

Default Initiator name and Data Digest settings:

iscsi:”192.168.0.2”:”3261”:”000000000000000E”:”iqn.2009-4.com:1234567890

”::”E”::”E”

o

Target IP address: 192.168.0.2

o

Target TCP port: 3261

o

Target boot LUN: 0x0E

o

Target iqn name: iqn.2009-04.com:1234567890

o

Initiator name: Not specified. Use the Initiator name already configured. Use the default name if

none was configured.

o

Header Digest: Enabled

o

Data digest: Not specified. Assume disabled.

o

Authentication Type: One-way CHAP

Advertising