HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 26)

Virtual Connect domains 26
Domain Settings (Backup/Restore) screen
Use this screen to create a backup file of the Virtual Connect domain configuration to restore a configuration
that has been lost, or to revert to a previously saved configuration. The domain configuration includes
network definitions, MAC address settings, WWN settings, Fibre Channel fabric settings, local user
accounts, and server profile definitions. The backup file stores the same information that is check-pointed
between the primary and backup modules during normal operation.
To back up a domain configuration:
1. Enter an encryption key to encrypt the configuration file.
2. Click Backup.
3. Navigate to the hard drive location where you want to save the configuration file.
4. Name the file (usually the domain name), and then click Save.
To restore a domain configuration:
CAUTION: Restoring a Virtual Connect domain configuration from a backup file that was
created on another Virtual Connect domain is not supported and can cause serious faults within
this and other Virtual Connect Domains within the environment. The restore selection and
configuration files should only be used to restore the same previously existing domain.
1. Click Browse, navigate to the location of the saved configuration file, select the file, and then click
Open.
2. Select the Ignore enclosure serial number in restored configuration file checkbox to restore a
configuration that was generated on another enclosure. If this item is not selected, a configuration
generated on another enclosure is rejected. This option is relevant to the primary/local enclosure only.