HP Officejet 6500 - Manual (Page 94)

To collate copies from the control panel
1. Load originals in the ADF. For more information, see
Load originals .
2. Press Copy repeatedly until Collate appears.
3. Press until the On setting appears, and then press OK.
Apply Margin Shift to a Copy Job
Margin shift allows you to shift the copy image on the printed page to allow for binding or
a 3–hole punch. The image is shifted to the right by 3/8 inch.
NOTE: An image may be cropped on the right edge because the copied image is
not scaled down by the Margin Shift feature.
NOTE: If you are using an HP Officejet 6500 (E709d) or HP Officejet 6500 (E709r),
this setting is not available. To determine the model you have, see
Finding the device
model number .
To apply margin shift from the control panel
1. Place your original face down on the scanner glass or load originals in the ADF. For
more information, see Load originals .
2. Press Copy repeatedly until Margin Shift appears.
3. Press until the On setting appears, and then press OK.
Two-sided copy jobs
NOTE: Two-sided copying is only available on some models. If two-sided copying
is not available, this option will not be displayed.
Two-sided copying allows you to print copies on both sides of a sheet of paper. It can be
done via the flatbed scanner or the ADF.
NOTE: If you are copying from the flatbed scanner, the display will prompt you when
it is time to load the second page.
Two-sided copying is not supported for small media.
NOTE: If you are using an HP Officejet 6500 (E709d) or HP Officejet 6500 (E709r),
this setting is not available. To determine the model you have, see
Finding the device
model number .
To make two-sided copies from the control panel
1. Place your original face down on the scanner glass or load originals in the ADF. For
more information, see Load originals .
2. Press Copy repeatedly until Two-sided appears.
3. Press to select 1-side or 2-side, and then press OK.
Chapter 7
90 Copy