HP H-series Enterprise Fabric Management Suite Software User Manual
Page 48
48
Managing Fabrics
a. Choose one of the following options from Select Set of Zoning Commands to View:
• Comprehensive Zoning Commands for Initial TR Setup shows the list of zoning commands to set
up all the IFZs.
• Zoning Commands Only for Changes to TR Mappings shows the list of zoning commands only
for changes you make during this session (after opening the TR Mapping Manager dialog box).
NOTE:
The Remote Fabric Zoning dialog box displays the Select Set of Zoning Commands to View
option only if you made and saved changes in the TR Mapping Manager dialog box. If you open
the Remote Fabric Zoning dialog box after selecting File > Generate Remote Zoning, the Select Set
of Zoning Commands to View option does not appear, and the Suggested Remote Fabric Zoning
Commands window displays the list of zoning commands to set up all the IFZs.
b. Choose one of the following options from the Remote Switch Type drop-down list to generate the
corresponding zoning commands:
• B-series—to connect remotely with B-series switches
• C-series—to connect remotely with C-series switches
c. Enter the Configuration Name, which is used as the zone set name in the commands. This must be
the same zone set name as the zone set on the remote fabric to which this zoning is applied, or else
the commands generated can be saved and edited to change the zone set name as needed. The
default Configuration Name is TRoutesCfg.
d. Configure the command list to either modify the existing zoning on the remote fabric, or to create
and activate new zoning.
• Clear the New Configuration option to add the changes to the existing active zone set. The
specified configuration and the active zone set must have the same name. If the names are not
the same, the application attempts to replace the active zone set with a new zone set with the
new name, containing only the Inter Fabric Zones. The active zone set will not be replaced
unless you respond to CLI queries to accept activation of this new zone set.
• Select the New Configuration option to create and activate a new active zone set. The specified
configuration name becomes the name of the active zone set.
5.
Click Export, and select a path name (TXT file extension only) in the Save dialog box. Selecting the
same path name overwrites the first path name.
6.
Click Save to save the zoning commands text file on your workstation.
NOTE:
The commands generated for C-series switches assume that zoning is applied to VSAN 1. If
this is not the correct VSAN, you must edit the commands accordingly before executing the
commands.