Jumper settings – HP StorageWorks Modular Arrays User Manual
Page 13
Introduction 1-3
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: Compaq StorageWorks 64-Bit PCI-To-Fibre Channel Host Bus Adapter User Guide Comments:
Part Number: AA-RKPDA-TE 173841-001 File Name: B-CH1 INTRODUCTION.DOC Last Saved On: 12/22/99 12:32 PM
Table 1-1
64-Bit PCI-to-Fibre Channel Host Bus Adapter
Figure Legend
Description
1
Fibre channel connector
2
LED Indicates the Embedded Optical Receive port is
receiving light.
3
POST LEDs indicators
Note: see Tables 2-1 and 4-1 for detailed descriptions
4
Jx1 jumper (see Table 1-2)
5
Jx2 jumper (see Table 1-2)
6
Not used
Jumper Settings
Two jumper blocks (JX1 and JX2) are used to control the HBA’s Device ID.
The default device ID setting for the HBA is F800. The jumper settings
defined in table 1-2 must be maintained for proper HBA operation.
Table 1-2
HBA Jumper Settings
Jumper
Pins
Description
Device ID
Comments
JX1
1-2
JX2 disabled
F800
Default
JX2
2-3
F800
Default