Document Outline

• Bit PCI-To-Fibre Channel Host Bus Adapter
  • Contents
  • About This Guide
    • Text Conventions
    • Symbols in Text
    • Symbols on Equipment
    • Getting Help
      • Compaq Technical Support
      • Compaq Website
      • Compaq Authorized Reseller
  • Introduction
    • Overview
    • Product Description
    • Jumper Settings
    • Performance Specifications
    • Standards
    • Agency Approvals
  • Installation
    • Installation Overview
    • Hardware Requirements
    • Software and Documentation Requirements
    • Recording Reference Numbers
      • Recording the Address and Serial Number
    • Installing the HBA into a Computer
    • Verifying the Installation
    • Configuration Guidelines for Operating Systems
  • Device Driver Installation
    • Introduction
    • Windows NT 4.0 System Requirements
    • Installing the Windows NT SCSI Device Driver
    • Verifying the Device Driver Installation
    • Removing the Device Driver
    • Tru64Unix Driver and Console Software
      • SHOW ADAPTER / -SET ADAPTER Commands
      • SHOW ADAPTER Command
    • OpenVMS Driver and Console Software
  • Troubleshooting
    • Introduction
    • POST Conditions and Results
    • The Windows NT Event Viewer
    • Windows NT Miniport Event Log Codes
    • Windows NT SCSI Address Mapping
      • Fabric Device Mapping
      • Private Loop Device Mapping
  • Firmware and Diagnostic Utility
    • Introduction
    • The Diagnostic and Firmware Download Utility
    • i386 System Installation
      • Starting
      • in an i386 System
      • Starting Alpha Systems with Alpha BIOS
      • Start-Up for Alpha/i386 Systems
    • Diagnostics Main Menu
      • Test Host Bus Adapters
      • Modify Test Options
      • Restart Host Bus Adapters
      • Input/Output
      • Maintenance
      • Show Host Bus Adapter Info
      • Quit
    • The Diagnostic and Firmware Loader Utility
  • Using LPUTILNT Utility/NT
    • Introduction
    • Viewing HBA Parameters
    • Performing HBA Firmware Maintenance
      • Upgrading HBA Firmware
      • Deleting or Activating Firmware Image
      • Enabling or Disabling Boot BIOS
    • Downloading PCI Configuration Files
    • Modifying Driver Parameters in the Windows NT Registry
  • Boot BIOS
    • Introduction
    • System Requirements
    • RA8000 or ESA12000 Boot Setup
      • Disk In-line Exerciser
      • The Auto-Configure Option
    • Defining a Fibre Channel Drive as the Boot Drive
      • Enabling Boot BIOS
      • Creating an MS-DOS Boot Diskette
      • Designating a Fibre Channel Boot Drive on Your Computer
      • Formatting the Fibre Channel Drive on Your Computer
      • Enabling HBA Boot BIOS on a Fibre Channel Hard Drive
      • Installing Windows NT
  • Appendix A
    • Regulatory Compliance Notices
      • FCC Compliance Information Statement Model LP8000- F1 (1 X 9)
        • Reference Manual Statements for Class B Equipment
        • VCCI
        • Federal Communications Commission Notice
    • Glossary
    • Index
      • A
      • B
      • C
      • D
      • E
      • F
      • G
      • H
      • I
      • J
      • K
      • L
      • O
      • P
      • R
      • S
      • T
      • V
      • W