Installing windows nt – HP StorageWorks Modular Arrays User Manual
Page 79
Boot BIOS 7-9
Compaq Confidential – Need to Know Required
Writer: Bill Reitz Project: Compaq StorageWorks 64-Bit PCI-To-Fibre Channel Host Bus Adapter User Guide Comments:
Part Number: AA-RKPDA-TE 173941-001 File Name: H-CH7 BOOT BIOS.DOC Last Saved On: 12/8/99 11:04 AM
25.
Exit the Boot BIOS and reboot your computer using the MS-DOS
diskette.
26.
From MS-DOS run fdisk.
27.
Delete any previous partition on the logical unit and then create a new
partition using the entire unit.
28.
Reboot your computer to let the fdisk changes take effect.
29.
Follow the Windows NT 4.0 setup procedure to install the Windows NT
4.0 operating system on the selected fibre channel boot drive.
Installing Windows NT
These steps summarize the installation script provided by Windows NT.
Consult the Windows NT documentation for detailed descriptions.
1.
Boot your computer with the Windows NT installation diskette #1 in
drive A.
2.
When prompted the first time, press the Enter key to allow the Windows
NT installation to detect the CD-ROM drive.
3.
When prompted a second time, press the S key to skip mass storage
device detection.
NOTE: Bypassing this step permits manual detection of additional HBAs.
4.
Select other and press Enter.
5.
From the supplied software kit Insert Diskette # 2 I386 Driver,
Windows NT SCSI driver diskette.
6.
Select the Fibre Channel SCSI driver and press Enter.
7.
Insert the Windows NT CD-ROM when prompted.