Remove the access panel, Install the access panel, Remove the sas controller – HP ProLiant BL420c Gen8 Server Blade User Manual
Page 14
Operations 14
Remove the access panel
To remove the component:
1.
Power down the server blade (on page
2.
Remove the server blade (on page
3.
Press the access panel release button.
4.
Slide the access panel towards the rear of the server blade, and then lift to remove the panel.
Install the access panel
1.
Place the access panel on top of the server blade.
2.
Slide the access panel forward until it clicks into place.
Remove the SAS controller
1.
Power down the server blade (on page
2.
Remove the server blade (on page
3.
Remove the access panel (on page
4.
Disconnect the capacitor pack cabling, if connected ("
" on page
CAUTION:
Always remove the SAS controller before removing the drive cage.
CAUTION:
Always be sure that both captive screws are disengaged before removing the SAS
controller. Failure to disengage the screws may result in damage to the SAS controller or the SAS
backplane and bracket.
5.
Remove the SAS controller.