HP ProLiant BL420c Gen8 Server Blade - Manual (Page 35)

Hardware options installation 35
9. Install the DIMM.
10. Install all DIMM baffles.
11. Install the SAS controller (on page 15 ).
12. Install the access panel (on page 14 ).
To configure the memory mode, use RBSU (" HP ROM-Based Setup Utility " on page 56 ).
Mezzanine card option
Optional mezzanine cards are classified as Type A mezzanine cards and Type B mezzanine cards. The type
of the mezzanine card determines where it can be installed in the server blade.
• Install Type A mezzanine cards on Mezzanine 1 connector or Mezzanine 2 connector.
• Install Type B mezzanine cards on Mezzanine 2 connector.
Optional mezzanine cards enable network connectivity or provide Fibre Channel support. For mezzanine
card locations, see the system board components (on page 8 ).
When installing a mezzanine option on mezzanine connector 2, processor 2 must be installed.
For mezzanine card mapping, see the HP ProLiant BL420c Gen8 Server Blade Installation Instructions or see
"Interconnect bay numbering and device mapping (on page
19 )."
To install the component:
1. Power down the server blade (on page 12 ).
2. Remove the server blade (on page 13 ).
3. Remove the access panel.