HP ProLiant BL420c Gen8 Server Blade - Manual (Page 37)

Hardware options installation 37
6. Install the mezzanine card in the mezzanine assembly, and then tighten the mezzanine card screws to
secure the card to the mezzanine assembly.
7. Align the mezzanine assembly with the guide pins on the system board, and then install the mezzanine
assembly on the system board.
8. Press down firmly on the mezzanine assembly handles, and then close the mezzanine assembly latch.
9. Install the access panel (on page 14 ).
10. Install the server blade (" Installing a server blade " on page 21 ).
SAS controller option
1. Power down the server blade (on page 12 ).
2. Remove the server blade (on page 13 ).
3. Remove the access panel (on page 14 ).
4. Disconnect the capacitor pack cabling, if connected (" FBWC capacitor pack cabling " on page 46 ).