Using the dns naming feature – HP Lights-Out 100 Remote Management User Manual
Page 11
a.
Press the down arrow (
↓) key to navigate to IPMI. Press the Enter key.
b.
Press the down arrow (
↓) key to navigate to LAN Settings. Press the Enter key.
c.
Set IP Address Assignment to DHCP.
•
On ML150 G6 servers:
a.
Press the down arrow (
↓) key to navigate to IPMI.
b.
Scroll to BMC LAN Configuration. Press the Enter key.
•
On DL160 G6, DL160se G6, DL180 G6, and SL160z G6 servers:
a.
Press the down arrow (
↓) key to navigate to IPMI Configuration.
b.
Scroll to Set LAN Configuration, and then scroll to BMC LAN Configuration. Press
the Enter key.
•
On DL170h G6, SL170z G6, SL170s G6, and SL2x170z G6 servers:
a.
Press the down arrow (
↓) key to navigate to IPMI Configuration.
b.
Scroll to LAN Configuration, and then scroll to DHCP IP Source.
c.
Select either of the following:
— To set BMC NIC to DHCP, scroll down to DHCP IP Source, and then to enable,
press the Enter key.
— To save all changes and exit, press the F10 key.
5.
To return to the previous screen, press the Esc key, or to save the changes and exit Setup,
press the F10 key.
To configure or change your network settings, see "
.
Using the DNS naming feature
The DNS naming feature enables you to reference the server name assigned to the server without
having to know the server IP address or obtaining the IP address for a given server. This ability
to reference the server name occurs after the server has registered its name with the DNS, using
the default naming sequence assigned by LO100, LO100 - {Server Serial Number}. (For
example, LO100 - CNQ123456.)
NOTE:
This requires DHCP and will not work with static IP addresses.
To obtain the serial number, look at the pull-out tab usually located in the front panel of the
server.
You can change the server name through the Network Settings page of the LO100 web interface.
You can also change the server name through the telnet interface.
To do this, type the following in the telnet interface:
cd map1/nic1
set oemhp_hostname=<new_name>
where
<new_name>
is the new DNS host name your server will have.
To retrieve a server IP address using the DNS naming feature, use a system connected to the
same network, open a DOS command prompt, and then type nslookup {server name}. (For
example, nslookup {CBQ123456}.)
Depending on your DNS server configuration, it might take up to 45 minutes for the DNS to
register a server name. For more DNS options in LO100, see "Configuring network settings using
a web browser".
Using TCP/IP over Ethernet management port
11