HP Lights-Out 100 Remote Management - Manual (Page 30)

cd map1
oemhp i 20 10 D0 18 00 12 01 03 D2
oemhp i 20 10 D0 18 00 12 02 3F 95
To configure a PEF for a particular sensor, click the PEF button to the far right of that sensor on
the Monitoring Sensors screen. The PEF button adjacent to each sensor opens a PEF Configuration
page for that sensor.
The PEF Configuration screen contains two sections: Current PEF Entries and Add PEF Entry.
The Current PEF Entries section includes Sensor Type, Sensor Name, PEF Action, and PEF Control
information. The Add PEF Entry section enables you set an action.
Initially, there are no entries are in the Current PEF Entries section because no PEFs are defined.
When PEF entries are defined, the PEF Control field is active and enables you to set the individual
entries to enabled, disabled, or deleted.
To configure an action (PEF entry), select the desired Event Offsets, select the desired PEF Action
settings, and then click Add.
• Event Offsets—Are trip points (movements across thresholds) that define what type of
sensor event triggers an action. The information in the Events Offsets section varies with
the type of sensor. Not all options are available for all sensors. You can select any of the
available options.
• PEF Action—Displays the same information for all sensors:
— Sensor Type—Displays the type of sensor selected.
— Sensor Name—Displays the name of the sensor.
— PEF Action—Enables you to select from Power Off, Power Cycle, Hard Reset, and Send
Alert (requires a systems management console supporting IPMI 1.5 or later).
— PEF Control—Enables or disables the sensor.
— Alert Policy (list adjacent to the Add button)—Enables you to select an alert policy (if
defined). Alert policies are defined on the PET Configuration screen. For information,
see "Platform event trap configuration."
If alert policies are not defined (default), the Alert Policy list displays No Alert Policy.
The Alert Policy list populates after alert policies are defined and configured. After
30 Using LO100