HP Lights-Out 100 Remote Management - Manual (Page 24)

Firmware Upgrade Diskette Utility available for download from the HP website ( http://
www.hp.com/servers/lights-out ).
— Specify one of the following:
◦ "-oemhpfiletype csr" for loading firmware
◦ "-oemhpfiletype key" for loading a key
◦ "-oemhpfiletype cer" for loading a certificate
Example:
/./map1/firmware/-> load -s //16.110.181.187/404.bin -oemhpfiletype csr
Firmware download is in progress.
BMC will be automatically reset once image is programmed and validated.
Checking Image 197120
Erasing Memory 2227924
Dnlding/Prgming 4194304
Time elapsed: 53 seconds.
Download Complete.
• The reset command causes a target to cycle from enabled to disabled and then to enabled
again.
• The set command assigns a specific value to a property or group of properties. The standard
syntax for the set command is
set property=new value
.
The set command is used to change any changeable property. If the current directory does
not contain the property you want to change, you must specify the target of the property
before entering the property you want to change.
• The start command causes the system1 target to power on.
• The stop command causes the system1 target to power off.
• The version command queries the version of the CLP implementation or other CLP
elements. For example:
/./map1/-> version
Version 1.00
/./map1/-> cd firmware
/./map1/firmware/-> version
Version 1.00
/./map1/firmware/-> show
/./map1/firmware
Targets
Properties
fwversion=0.59
Verbs
cd
version
exit
show
reset
load
help
/./map1/firmware/-> show fwversion
fwversion=0.59
/./map1/firmware/-> fwversion
Invalid command
/./map1/firmware/->
24 Using LO100