HP Lights-Out 100 Remote Management User Manual
Page 12
Setting up a static IP address from the BIOS Setup Utility
By default, LO100 has DHCP enabled and automatically negotiates an IP address. To disable
DHCP and enable a static IP address:
1.
Press the F10 key during POST to enter the BIOS Setup Utility.
2.
Press the right arrow (
→) key to navigate to the Advanced menu.
3.
To set your network BIOS settings, choose one of these options:
•
On ML110 G6 and DL120 G6 servers:
a.
Press the down arrow (
↓) key to scroll to IPMI. Press the Enter key.
b.
Press the down arrow (
↓) key to scroll to the LAN Settings menu. Press the Enter
key.
c.
On IP Address Assignment, select Static.
•
On ML150 G6 servers:
a.
Press the down arrow (
↓) key to scroll to IPMI. Press the Enter key.
b.
Press the down arrow (
↓) key to scroll to the end, and then select BMC LAN
Configuration.
c.
On BMC LAN Configuration, select Static.
d.
Press the down arrow (
↓) key to scroll down and enter a valid IP address, subnet
mask, and gateway address (press the Tab key to move between address fields).
•
On DL160 G6, DL160se G6, DL180 G6, and SL160z G6 servers:
a.
Press the down arrow (
↓) key to scroll to IPMI. Press the Enter key.
b.
Press the down arrow (
↓) key to scroll to the LAN Configuration menu. Press the
Enter key.
c.
On DHCP IP Source, select Disabled.
d.
Press the down arrow (
↓) key to scroll down and enter a valid IP address, subnet
mask, and gateway address (press the Tab or period (.) key to move between
address fields).
•
On DL170h G6, SL170z G6, SL170s G6 and SL2x170z G6 servers:
a.
Press the down arrow (
↓) key to scroll to IPMI Configuration. Press the Enter key.
b.
Press the down arrow (
↓) key to scroll to the LAN Configuration menu. Press the
Enter key.
c.
Press the down arrow (
↓) key to scroll to the end, and then select DHCP IP Source.
d.
Select either of the following:
— To set BMC NIC to Disabled, press the Enter key.
•
On DL165 G7 and And SL 165 G7 servers:
a.
Press the down arrow (
↓) key to scroll to IPMI Configuration. Press the Enter key.
b.
Press the down arrow (
↓) key to scroll to the LAN Configuration menu. Press the
Enter key.
c.
Press the down arrow (
↓) key to scroll to the BMC LAN Configuration menu. Press
the Enter key.
d.
Select DHCP/static, then press the Enter key.
— To save all changes and exit, press the F10 key. To save all changes and exit, press
the F10 key.
4.
Press the F10 key to save and exit.
To restore DHCP, see "Configuring network settings using the BIOS Setup Utility."
Enabling or disabling Telnet and HTTP services from the BIOS Setup Utility
On ML110 G6 and DL120 G6 servers:
12
Configuration