HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 12)

Setup 12
3. Run the Fibre Channel setup wizard (" HP Virtual Connect Fibre Channel Setup Wizard " on page
85 ).
a. Select a WWN range to be used by server blade FC HBAs (" WWN settings " on page 86 ).
b. Define the SAN fabrics.
4. Run the Server Profile wizard (" Virtual Connect Manager Server Profile Wizard " on page 91 ).
a. Define a server profile template.
b. Assign server profiles.
c. Name server profiles.
d. Create server profiles.
After an enclosure is imported into a Virtual Connect domain, server blades that have not been assigned
a server profile are isolated from all networks to ensure that only properly configured server blades are
attached to data center networks.
A server profile can be assigned and defined for each device bay so that the server blade can be
powered on and connected to a deployment network. These profiles can then later be modified or
replaced by another Server Profile (" Server Profiles screen " on page 158 ).
A server profile can also be assigned to an empty bay to allow deployment at a later date.