HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 182)

Domain management 182
• Compaq System Info MIB
• RFC 3418 SNMPv2-MIB
• RFC 2863 IF-MIB
• RFC 4188 BRIDGE-MIB
The VC-Enet module supports the following SNMP traps:
• cpqHoSWRunningStatusChangeTrap from CPQ-HOST MIB
The VC domain status has changed as described in the next section.
• coldStart trap from SNMPv2-MIB
CRITICAL—A coldStart trap signifies that the SNMP agent is reinitializing itself and that its
configuration might have been altered.
The VC-FC module supports the applicable groups of the following SNMP MIBs:
• Compaq Host MIB
• Compaq System Info MIB
• Compaq Rack MIB
The VC-FC module supports the following FC industry standard MIBs:
• Fibre Alliance MIB
• Fabric Element MIB
The VC-FC module supports the following SNMP traps:
• connUnitStatusChange (1.3.6.1.3.94.0.1)
INFO—The overall status of the connectivity unit has changed. Status is sent when any of the
following notifications occur:
o Switch.OperChange
o Switch.StateChange
• connUnitDeletedTrap (1.3.6.1.3.94.0.3)
INFO—A connUnit has been deleted from this agent. Status is sent when an Eport.OperChange
event occurs and the connUnitTable is smaller than previously noted.
• connUnitEventTrap (1.3.6.1.3.94.0.4)
INFO—An event has been generated by the connectivity unit. Status is sent when a change
notification occurs that does not fit into any other specific category.
• connUnitSensorStatusChange (1.3.6.1.3.94.0.5)
CRITICAL—The overall status of the connectivity unit has changed. Status is sent when any of the
following notifications occur:
o Chassis.PsBadAlarm
o Chassis.PsOkAlarm
o Chassis.FanBadAlarm
o Chassis.FanOkAlarm
o Blade.OverheatAlarm
o Blade.OverwarmAlarm