HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 211)

Hardware information screens 211
• The module must be physically removed from the bay.
• The interconnect bay must remain empty for this procedure.
• The module uplink and downlink ports cannot be in use by networks, uplink sets, or profiles
(including FC profiles) in the enclosure.
• Port monitoring cannot be enabled on that bay.
VC-FC conditions:
• The user must have Domain privileges.
• Physically remove the module from the bay.
• The interconnect bay must remain empty for this procedure.
• Change all fabrics on that module to Unassigned for all Virtual Connect profile configurations.
If these conditions are met, click Remove from Domain.
If these conditions are not met, the Remove from Domain button is not available, or an error message is
displayed.
Interconnect Bay Overall Status icon definitions
Icon Operational state Meaning Corrective action
OK Device is fully operational. None
Unknown Device operational state cannot be
determined. Check Onboard Administrator
communication.
(blue)
Initializing Device is initializing. Wait until initialization is complete.
(This icon should only be seen at
startup.)
(yellow)
Degraded Device is partially operational, but
capability is lost. Check and correct the Onboard
Administrator error condition.
(orange)
Misconfigured Device has a configuration error. Correct the Virtual Connect Manager
configuration attributes.
(orange)
Incompatible Device does not match the
configuration. Remove the incorrect hardware. Insert
the correct module.
(orange)
No communication Cannot communicate with the
device.
Check the physical connections and IP
address.
Missing Device is configured but not
accessible. Insert the correct hardware module.
Failed Device is not operational because
of an error. Reset the device or application, or
replace the device.
Interconnect Bay OA Reported Status icon definitions
Icon Operational state Meaning Corrective action
OK Device is fully operational. None
Unknown Device operational state cannot be
determined.
Check Onboard Administrator
communication.