HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 42)

Installation 42
Ensure that the latch is closed and that the transceiver is fully seated.
3. Do one of the following:
o Connect the appropriate cable.
o Install the dust plug onto the transceiver.
Removing SFP/SFP+/XFP transceivers
WARNING: To avoid serious injury, never look directly into an open transceiver port.
CAUTION: Disconnect all cables before removing or installing an SFP/SFP+/XFP transceiver,
because of the potential damage to the cables, the cable connector, or the optical interfaces in
the transceiver.
Removing and installing a transceiver can shorten the useful life. Do not remove and insert
transceivers more often than is necessary.
1. Disconnect all cables.
2. Open the latch.