HP Deskjet F375 All-in-One Printer - Manual (Page 45)

The minimum system checks screen appears (Windows)
Solution Your system does not meet the minimum requirements to install the
software. Click Details to see what the specific problem is, and then correct the
problem before attempting to install the software.
You can also try installing HP Photosmart Essential instead. HP Photosmart
Essential provides less functionality than the HP Photosmart Premier software,
but it requires less space and memory on your computer.
For more information about installing the HP Photosmart Essential software, see
the Setup Guide that came with the HP All-in-One.
A red X appears on the USB connect prompt
Solution Normally, a green check appears indicating that the plug and play is
successful. A red X indicates that the plug and play failed.
1.
Verify that the control panel overlay is firmly attached, unplug the HP All-in-
One power cord, and then plug it in again.
2. Verify that the USB cable and power cord are plugged in.
3. Click Retry to retry the plug and play setup. If this does not work, continue to
the next step.
4. Verify that the USB cable is set up properly as follows:
–
Unplug the USB cable and plug it in again.
– Do not attach the USB cable to a keyboard or non-powered hub.
– Verify that the USB cable is 3 meters (9.8 feet) or less in length.
– If you have several USB devices attached to your computer, you might
want to unplug the other devices during the installation.
5. Continue with the installation and restart the computer when prompted.
6. If you are using a Windows computer, open the HP Solution Center and
check for the essential icons ( Scan Picture and Scan Document ). If the
essential icons do not appear, remove the software and then reinstall it. For
more information, see
Uninstall and reinstall the software .
Chapter 10
42 HP Deskjet F300 All-in-One series
Troubleshooting