HP Deskjet F375 All-in-One Printer User Manual
Page 9
The following table describes common situations and explains what the lights mean.
Light status
What it means
All lights are off.
The HP All-in-One is turned off. Press the
On
button to turn on the device.
The
On
light and one of the Paper Type lights
are on.
The HP All-in-One is ready for printing,
scanning, or copying.
The
On
light is blinking.
The HP All-in-One is busy printing, scanning,
copying, or aligning the print cartridges.
The
On
light blinks quickly for 3 seconds and
then is on steady.
You pressed a button while the HP All-in-One
is already busy printing, scanning, copying, or
aligning the print cartridges.
The
On
light blinks for 20 seconds and then is
on steady.
You pressed the
Scan
button and there was
no response from the computer.
The Check Paper light is blinking.
●
The HP All-in-One is out of paper.
●
The HP All-in-One has a paper jam.
●
The paper size setting does not match
the paper size detected in the input tray.
The Check Print Cartridge light is blinking.
●
The print cartridge door is open.
●
The print cartridges are missing or not
seated correctly.
●
The tape was not removed from the print
cartridge.
●
The print cartridge is not intended for use
in this HP All-in-One.
●
The print cartridge might be defective.
The
On
, Check Paper, and Check Print
Cartridge lights are blinking.
Scanner failure.
Turn off the HP All-in-One, then on again. If
the problem persists, contact HP Support.
All lights are blinking.
The HP All-in-One has a fatal error.
1.
Turn the HP All-in-One off.
2.
Unplug the power cord.
3.
Wait a minute, then plug the power cord
back in.
4.
Turn the HP All-in-One back on.
If the problem persists, contact HP Support.
Chapter 1
6
HP Deskjet F300 All-in-One series
HP All-in-One
overview