HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem User Manual
Page 30
Domain management 30
IMPORTANT:
Virtual Connect Manager cannot use backup configurations created with
previous versions of Virtual Connect Manager. For example, if you are currently using v2.01,
you cannot use a backup configuration that was created using v1.20.
To back up a domain configuration:
1.
Click Backup Configuration.
2.
Navigate to the hard drive location for the backup file.
3.
Name the file (usually the domain name), and then click Save.
To restore a domain configuration:
1.
Enter or browse to the backup file.
2.
Select the file.
3.
Select the Ignore enclosure serial number in restored configuration file checkbox to restore a
configuration that was generated on another enclosure. If this item is not selected, a configuration
generated on another enclosure is rejected.
4.
Select the Disallow restore of 1.1x configuration file checkbox to restore the firmware to a revision
other than what is stored in the configuration file.
5.
Click Restore Configuration.
6.
Confirm the domain configuration to be restored, and then click OK.
If restoring a configuration file that has multiple enclosures, each remote enclosure must be re-
authenticated for security reasons.
For additional information, see "Recovering remote enclosures (on page
)."