HP 1.10GB Virtual Connect Ethernet Module for c-Class BladeSystem - Manual (Page 58)

Network management 58
This screen has similar fields to the Define Ethernet Network screen (on page 54 ). This screen can only be
edited by users with network privileges, but it is viewable by all authorized users.
The following table describes the fields within the Edit Network screen.
Field name Description
Network
Network Name Name of the network
Enabled Displays the current state of the network as enabled (checked) or
disabled (unchecked)
Status Displays the current status of the network
PID PID status for the overall network
Advanced Network Settings If checked, displays additional selections for advanced network
settings
Smart Link Shows whether Smart Link is enabled (checked) or disabled
(unchecked)
Private Network Shows whether this network is designated (checked) or not
designated (unchecked) as a private network
Enable VLAN Tunneling Shows whether VLAN tunneling is enabled (checked) or disabled
(unchecked)
External Uplink Ports
Use Shared Uplink Set Enables selection or creation of a shared uplink set
Port Network port locations (enclosure, bay, and port numbers)
Port Role Applicable when Failover Connection Mode is selected. The port can
be designated as Primary or Secondary.
Port Status Displays the current linked status of the selected port
Connector Type Displays the type of connector on the port; for example, RJ-45
Connected to If the port is connected to a switch that supports LLDP, the switch
MAC address and switch port number appear. A link is provided to
obtain more information about the far-end switch port.