HP Virtual Connect 1.10Gb-F Ethernet Module for c-Class BladeSystem - Manual (Page 37)

Command line 37
Item Description
Severity (optional) Severity of the log messages that should be sent to the specified destination.
Valid values include "Critical", "Error", "Warning", and "Info". The default
value is "Info".
Transport (optional) The transport protocol to be used for sending the log messages to the
destination. Valid values include "TCP" and "UDP". The default value is "UDP".
Port (optional) Secure transmission of the log messages. Valid values include "None" and
"STunnel". The Default value is "None", and no encryption is used during
transmission.
The "STunnel" option can be used only if the transport protocol used is TCP.
Format (optional) The timestamp format for the log messages. Valid values include "RFC3164"
(Nov 26 13:15:55) and "ISO8601" (1997-07-16T19:20:30+01:00). The
default value is "RFC3164".
State (optional) Enables or disables the remote log destination. Valid values include "Enabled"
and "Disabled". The default value is "Disabled".
Examples
->set log-target 1 Severity=Error Transport=TCP
Security=STunnel
Modifies log-target index number 1
->set log-target 1 Destination=192.168.3.1
Modifies log-target at index 3 and modifies the IP address to a new one
Item Description
show lot-target Display the remote log destination settings.
Syntax show log-target [<ID|*>]
Property
ID (optional) The index of the remote log destination whose detailed configuration needs to
be viewed. '*' displays detailed information of all the remote log destinations.
Example
->show log-target
Displays all log destination settings
Item Description
test log-target Send a test message to all enabled remote log destinations.
Syntax test log-target
Example
->test log-target
Sends a test message all log-targets
mac-cache
Manage Ethernet MAC Cache failover settings.
Supported actions: help, set, show