HP Laserjet p3015 - Manual (Page 42)

I/O menu
Items on the I/O (input/output) menu affect the communication between the product and the computer.
If the product contains an HP Jetdirect print server, you can configure basic networking parameters by
using this submenu. You can also configure these and other parameters through HP Web Jetadmin or
the embedded Web server.
For more information on these options, see Network configuration on page 65 .
To display: Press the Menu button , select the CONFIGURE DEVICE menu, and then select the I/
O menu.
NOTE: Values that have an asterisk (*) are the factory-default values. Some menu items have no
default.
Item Sub-item Values Description
I/O TIMEOUT Range: 5 - 300 Set the product I/O TIMEOUT in
seconds. The default is 15
seconds.
Adjust timeout for the best
performance. If data from other
ports appears in the middle of your
print job, increase the timeout
value.
EMBEDDED JETDIRECT MENU
EIO <X> JETDIRECT MENU
See the next table for a list of options.
Embedded Jetdirect and EIO <X> Jetdirect menus
Item Sub-item Sub-item Values Description
INFORMATION PRINT SEC PAGE YES*
NO
YES: Prints a page that contains the current
security settings on the HP Jetdirect print
server.
NO: A security settings page is not printed.
TCP/IP ENABLE ON*
OFF
ON: Enable the TCP/IP protocol.
OFF: Disable the TCP/IP protocol.
HOST NAME An alphanumeric string, up to 32 characters,
used to identify the product. This name is
listed on the HP Jetdirect configuration page.
The default host name is NPIxxxxxx, where
xxxxxx is the last six digits of the LAN
hardware (MAC) address.
30 Chapter 2 Control panel ENWW