HP StorageWorks 2.32 Edge Switch - Manual (Page 181)

Edge Switch Element Manager user guide 181
• Click Default Threshold and a default value (1 to 99%) is displayed in the Threshold
field. If the default is enabled, you cannot enter values into the field.
• Click in the threshold field and enter a value from 1 to 99.
6. Click Activate.
Using the pop-up menu options
Right-click columns in the Congestion Threshold table to display menu options that globally
change values in the column cells. These columns are as follows:
Use Algorithmic Threshold
Right-click in the column to display these options:
• Set all to Default—Adds checks to all check boxes in this column and sets all cells of the
Threshold % column to default values.
• Clear All—Clears all check boxes in this column and restores the previous values in cells of the
Threshold % column.
Threshold %
Right-click in the column to display these options:
• Set All To xx—Sets all cells in this column to the value (xx) that you select.
• Restore All— Sets all cells in the column to the previous values.
Open Trunking Log
The Open Trunking log ( Figure 81 ) provides details on flow rerouting that is occurring through
switch ports.
Figure 81 Open Trunking log
This log contains the following columns:
• Date/Time—Date and time that action occurred.
• Receive Port—Decimal receive port number on the local switch associated with the flow that
was rerouted.
• Target Domain—Decimal domain ID associated with the flow that was rerouted.
• Old Exit Port—Decimal exit port number on this switch that the flow was using to get to the
target domain.
• New Exit Port—Decimal exit port number on this switch that the flow now uses to get to the
target domain.