HP Integrity NonStop H-Series - Manual (Page 23)

N1528A and N1529A ACL Tape Drive Installation and User’s Guide— 544594-002
3 -1
3
Installing and Configuring the ACL
Tape Drive for the NonStop S-Series
Server
This section includes these topics:
Installation Procedure for New Model
1. Check that the power switch on the tape drive is set to the off position. See
Figure 3-1 .
2. Connect the power cord to the tape drive’s AC power receptacle. See Figure 3-1 .
3. Make sure the power cord is fully seated.
Installation Procedure for New Model 3-1
Installation Procedure for Old Model 3-5
Configuration 3-9
Note. These ACL units are now shipped in a different type of chassis. The installation
procedure for the newer model is different from the older model. If you have the newer model,
please see
Installation Procedure for New Model for the installation procedure. For the
installation procedure for the older model see Installation Procedure for Old Model . The
configuration section applies to both types.
Note. Do not attach the male end of the power cord to a power outlet at this time.