HP Integrity NonStop H-Series - Manual (Page 27)

Installing and Configuring the ACL Tape Drive for the
NonStop S-Series Server
N1528A and N1529A ACL Tape Drive Installation and User’s Guide— 544594-002
3 -5
Installation Procedure for Old Model
Installation Procedure for Old Model
1. Check that the power switch on the tape drive is set to the off position. See
Figure 3-3 .
2. Connect the power cord to the tape drive’s AC power receptacle. See Figure 3-3 .
3. Make sure the power cord is fully seated.
4. Connect the 68-pin to 68-pin SCSI cable to the top SCSI port on the SCSI
Converter card. See Figure 3-5 .
5. Connect the other end of the SCSI cable to a supported SCSI port on the server.
You can attach the tape drive to a NonStop S-series server using one of the
following:
Note. Do not attach the male end of the power cord to a power outlet at this time.
Figure 3-3. View of Power Switch and Power Receptacle
Power Switch AC Power Receptacle