HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 120)

Command line 120
Item Description
Parameter
PortID (required) The ID of an uplink port to add. The ID is a combination of the enclosure name,
interconnect bay, and port number in a single descriptor. The port ID for a network or
an uplinkset that does not contain an FCoE network is in the format
<EnclosureID>:<InterconnectBay>:X<PortNumber>.
If the uplinkset contains an FCoE network, then the port is configured for all enclosures.
The port name is in the format <InterconnectBay>:X<PortNumber>.
Properties
Network
(required)
The name of an existing network to which the port is added if the shared uplink set
name is not specified
UplinkSet
(required)
The name of an existing shared uplink set to which the port is added if the network
name is not specified
Speed (optional) Specifies the port speed for the port (optional). Valid values are "Auto", "10Mb",
"100Mb", "1Gb", "10Gb", and "Disabled". If not specified, the default port speed is
"Auto". If no connector is present on the uplink port, only "Auto" and "Disabled" can
be configured as the speed. Speed restrictions apply.
Role (optional) The role played by the port if the connection mode of the network or shared uplink set
is selected as "Failover". Valid values are "Primary" and "Secondary". The default
value is "Primary". If the uplink set contains an FCoE network, then the Role property is
not allowed.
Examples
->add uplinkport enc0:1:1 Network=MyNetwork
Adds a new uplink port (Bay 1, Port 1) to a network named MyNetwork
->add uplinkport enc0:2:4 Network=MyNetwork Speed=1Gb
Adds a new uplink port (Bay 2, Port 4) to a network and sets the port speed
->add uplinkport enc0:2:3 UplinkSet=MyUplinkSet
Adds a new uplink port (Bay 2, Port 3) to a shared uplink set
->add uplinkport enc0:2:4 Network=MyNetwork Role=Primary
Adds a new uplink port to a network with the connection mode as "Failover" and the
port role as "Primary"
->add uplinkport 1:X2 UplinkSet=MyUplinkSet
Adds a new uplink port (Bay 1, Port 2) to a shared uplink set that contains an FCoE
network
Item Description
remove uplinkport Remove an uplink port element from a network or a shared uplink port set.
Syntax
remove uplinkport <PortID> [Network=<NetworkName> |
UplinkSet=<UplinkSetName>]
Parameter
PortID (required) The ID of the port to remove from a network. The specified port must already be added
to a network or uplink port set. The port name for a network or uplinkset that does not
contain an FCoE network is in the format
<EnclosureID>:<InterconnectBay>:X<PortNumber>.
If the uplinkset contains an FCoE network, then the port is configured for all enclosures.
The port ID is in the format <InterconnectBay>:X<PortNumber>.
Properties
Network
(required)
The name of the network from which the port is removed if the UplinkSet name is not
specified
UplinkSet
(required)
The name of the shared uplink set from which the port is removed if the Network name
is not specified