HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem User Manual
Page 180
Advertising
Configuring the Virtual Connect domain using the CLI 180
You are logged out of the session after approximately 1 minute. If you attempt to log in to the module again,
you might receive the following error message:
Unable to communicate with the Virtual Connect Manager. Please retry again
later.
The login should succeed after the Virtual Connect Manager restarts. Allow up to 5 minutes, depending on
the enclosure configuration.
Advertising
This manual is related to the following products:
- Virtual Connect 8Gb 20-port Fibre Channel Module for c-Class BladeSystem Virtual Connect Flex-10.10D Module for c-Class BladeSystem Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem 4GB Virtual Connect Fibre Channel Module for c-Class BladeSystem Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem