HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem - Manual (Page 168)

Configuring the Virtual Connect domain using the CLI 168
Server profiles are associated with a specific enclosure device bay. After a profile is assigned, the Virtual
Connect Manager configures the server blade in that device bay with the appropriate MAC, PXE, WWN,
and SAN boot settings and connects the appropriate networks and fabrics. Server blades that have been
assigned a profile and remain in the same device bay do not require further Virtual Connect Manager
configuration during a server or enclosure power cycle. They boot and gain access to the network and fabric
when the server and interconnect modules are ready.
If a server blade is installed in a device bay already assigned a server profile, Virtual Connect Manager
automatically updates the configuration of that server blade before it can power on and connect to the
network.
If a server blade is moved from a Virtual Connect-managed enclosure to a non-Virtual Connect enclosure, the
MAC addresses and WWNs for the blade are automatically returned to the original factory defaults. This
feature prevents duplicate MAC addresses and WWNs from appearing in the data center because of a
server blade redeployment.
Creating server profiles
To create a new server profile, use the add profile command:
>add profile MyNewProfile
To copy the configuration from one profile to another profile, use the following command:
>copy ExistingProfile MyNewProfile
After an enclosure is imported into a Virtual Connect domain, server blades that have not been assigned a
server profile are isolated from all networks to ensure that only properly configured server blades are
attached to data center networks.
A server profile can be assigned and defined for each device bay so that the server blade can be powered
on and connected to a deployment network. These profiles can then later be modified or replaced by another
server profile.
A server profile can also be assigned to an empty bay to enable deployment at a later date.
Adding Ethernet network connections to a profile
To add a new Ethernet network connection to an existing server profile, use the add enet-connection
command:
>add enet-connection MyProfile network=MyNetwork pxe=enabled
To add a multiple network Ethernet connection on a server port, use the following commands:
>add enet-connection MyProfile pxe=enabled
>add server-port-map MyProfile:1 MyNetwork VlanID=100
>add server-port-map-range MyProfile:1 VLanIds=151-170,215
If the domain setting for SharedServerVlanID is set to true, then the VlanID property cannot be
modified. Instead, the name of the shared uplink set with which the network is associated is required.
>add server-port-map MyProfile:1 MyNetwork Uplinkset=MyUplinkset
Adding iSCSI connections to a profile
To add a new iSCSI connection to an existing server profile, use the add iscsi-connection command:
>add iscsi-connection MyProfile network=MyNetwork speedType=custom
speed=2000
To configure the boot parameters for the iSCSI connection, use the set iscsi-boot-param command as
follows: