Adding fc fabric connections to a server profile, Adding fcoe connections to a profile, Adding a network access group to a profile – HP Virtual Connect 4Gb Fibre Channel Module for c-Class BladeSystem User Manual
Page 169: Assigning a server profile to a device bay, Configuring igmp settings
Configuring the Virtual Connect domain using the CLI 169
>set iscsi-boot-param MyProfile1:1 BootOrder=Primary Lun=100
InitiatorName="iqn.2009-09.com.someorg.iSCSI-Initiator"
InitiatorIp=192.128.3.1 Mask=255.255.0.0
TargetName="iqn.2009-09.com.someorg.iSCSI-Target" TargetIp=192.128.3.2
TargetPort=40000 Authentication=CHAP Username=SomeUserName
Secret=SomePassword123
Adding FC fabric connections to a server profile
To add a new FC SAN connection to an existing server profile, use the add fc-connection command:
>add fc-connection MyProfile fabric=SAN_5
For more information, see "General requirements for adding FC or FCoE connections (on page
)."
Adding FCoE connections to a profile
To add a new FCoE connection to an existing server profile, use the add fcoe-connection command:
>add fcoe-connection MyNewProfile Fabric=SAN_1 SpeedType=Custom
CustomSpeed=5000
To configure the boot parameters for the FCoE connection, use the set fcoe-connection command:
>set fcoe-connection MyNewProfile:1 BootPriority=Primary
BootPort=50:06:0B:00:00:C2:62:00 BootLun=5
For more information, see "General requirements for adding FC or FCoE connections (on page
)."
Adding a network access group to a profile
To create a new profile and assign an existing network access group, use the add profile command:
>add profile MyNewProfile2 Nag=DatabaseNetGroup
To modify the network access group of an existing server profile, use the set profile command:
>set profile Profile1 Nag=NetGroup1
Assigning a server profile to a device bay
To assign a server profile to a specific device bay, use the assign profile command:
>assign profile MyProfile enc0:1
When defining server profiles in a multi-enclosure configuration, profiles can be assigned to server bays in
any of the enclosures that have been added and imported into the domain.
When a profile is created and assigned to a multi-blade server, the profile is applied to all of the blades in
the multi-blade server. Be sure that the profile contains enough Ethernet and Fibre Channel connection entries
for all of the ports on all of the blades in the multi-blade server.
Configuring IGMP settings
IMPORTANT:
Users with server role permissions cannot modify IGMP settings when the VC
domain is under VCEM control.
To configure Ethernet IGMP snooping settings, use the set igmp command:
>set igmp Enabled=true Timeout=30