HP StorageWorks XP10000 Disk Array - Manual (Page 153)

IMPORTANT:
Do not change the NAS comment rows.
NOTE:
When you want to set the initiator/external mix mode for the PCB mode, set “HighSpeed” the same as
when you set the high-speed mode.
Table 20 lists the available configuration definitions for the [CHA] tag.
Table 20 Available Configuration Values for the [CHA] Tag
Column Item Available Values
1st, 11th
(Index)
CHA One of the following can be set:
CHA-1E, CHA-1F, CHA-1G, CHA-1H, CHA-1A, CHA-1B, CHA-1L, CHA-1K,
CHA-2Q, CHA-2R, CHA-2T, CHA-2U, CHA-2M, CHA-2N, CHA-2X, CHA-2W
2nd, 12th PCB Mode One of the following can be set:
High Speed mode (2 ports):
Standard: Standard mode (all ports)
HighSpeed: High Speed mode (all ports)
HighSpeed (Block-A): The upper four ports of the CHA are the High Speed
mode.
HighSpeed (Block-B): The lower four ports of the CHA are the High Speed
mode.
High Speed mode (32 ports):
Standard: Standard mode (all ports)
HighSpeed: High Speed mode (all ports)
HighSpeed (Block-ABCD): Define four blocks as A, B, C, D, and write only for
the High Speed mode in the order of A, B, C, D.
For example, when A is High Speed mode, you will write:
HighSpeed (Block-A)
Another example, when A, B, and D are High Speed mode, you will write:
HighSpeed (Block-ABD)
3rd-6th,
13th-16th
Blank
Port Settings
The [Port] tag allows you to set the port information and the change the security switch (Secure Manager
XP) to ON or OFF. You can change the [Port] tag definitions, but may not add or delete them.
You cannot change the NAS settings using the spreadsheet. However, the current NAS settings are
commented on the exported spreadsheet (the rows start with “#$”).
WARNING!
Do not change the NAS comment rows.
Table 21 lists the items and values available for the [Port] tag.
HP StorageWorks 153