HP LaserJet M9040M9050 Multifunction Printer series - Manual (Page 87)

Callout Area on the screen Information or capability that the area provides
4 LDAP Server Bind Method Anonymous Select this option to connect to the LDAP
server if the LDAP server does not
require user credentials to access the
LDAP database.
Simple Select this option to connect to the LDAP
server if the LDAP server requires user
credentials to use the LDAP database.
When this option is selected, you must
enter the user, password, and domain.
Note that the password will be sent
across the network unencrypted.
Simple over SSL Select this option to connect to the LDAP
server if the LDAP server requires user
credentials to use the LDAP database.
This option supports Kerberos v2.
When this option is selected, you must
enter the user, password, and domain.
NOTE: This option is not available for
all products.
Kerberos The selected LDAP (Active Directory)
Server requires user credentials. A
Kerberos ticket will be obtained from the
Kerberos (Active Directory) Server and
used to authenticate to the LDAP Server.
The Password will be sent across the
network encrypted and will be
unreadable to third parties.
In order to use Kerberos as a bind
method, you must first configure
Kerberos settings. If using “user's
credentials”, make sure that Kerberos
Authentication is required for E-mail.
5 Use Device User's Credentials You can only use this setting if Authentication is enabled for SMTP and
individual device users have accounts on the SMTP server. In most cases,
Use Public Credentials is the preferred method.
6 Use Public Credentials Use this setting to set a single name and password for SMTP authentication
for the device to use for all users.
These public credentials are used to connect to the LDAP directly. When
public credentials are entered, these credentials are used by the device to
access the LDAP directory when any user uses the device.
7 LDAP Server Type the host name or TCP/IP address of the LDAP server whose database
contains the centralized address book.
NOTE: Some products recognize only TCP/IP addresses. In such cases,
host names are converted to the equivalent TCP/IP address.
8 Port Type the TCP/IP port number on which the server is processing LDAP
requests. This is typically port 3268.
9 Find Server Click this button to search for available LDAP servers.
10 Find Settings Click this button to have the product attempt to determine the best settings
for the specified server when searching the LDAP database.
Table 4-9 Addressing Settings (continued)
ENWW Addressing Settings 75