HP XP Command View Advanced Edition Software User Manual
Page 431
3.
Check that the temporary file has been imported correctly.
To check that backup information bearing the date on which the storage groups had been backed
up from the primary volume to the secondary volume has been imported into the database server,
execute the
drmexgcat
command on the database server.
DBServer > drmexgcat
STORAGEGROUP: STR1
BACKUP-ID:0000000003 BACKUP-MODE: VSS STORAGEGROUP: STR1 ORIGINAL-ID:0000000001
START-TIME:2007/08/05 10:00:00 END-TIME: 2007/08/05 10:01:00 HOSTNAME:DBServer
T OBJECT INFORMATIONSTORE FILE FS DG DEVICE
COPY-GROUP
M MAILBOXSTORE MAILBOX1(STR1) D:\STR1\priv1.edb D: - Harddisk1
TC01,EXG11
- - - - - - -
TC01,EXG11
T TRANSACT - E:\STR1\E00*.log E: - Harddisk2
TC02,EXG12
- - - - - - -
TC02,EXG12
C CHECKPOINT - E:\STR1\E00.chk E: - Harddisk2
TC02,EXG12
- - - - - - -
TC02,EXG12
DBServer >
4.
Restore the data from the secondary volume to the primary volume.
Restore the data by resynchronizing the primary and secondary volumes. To restore the data,
execute
EX_DRM_EXG_RESTORE
on the database server.
DBServer > EX_DRM_EXG_RESTORE Operation_A -resync
5.
Resynchronize the copy groups.
To resynchronize the copy groups, execute
EX_DRM_RESYNC
on the database server.
DBServer > EX_DRM_RESYNC Operation_A
Backing up and restoring in a cascade configuration
This section provides an example of backing up and restoring in a system configuration that consists
of a database server and a backup server in a cascade configuration. The explanations in this section
use operation examples for Exchange Server 2007.
The following examples are provided:
•
Performing backups using VSS concurrently at both the local and remote sites (backup data is
created on secondary volumes). In this example, the backup data on the secondary volumes is
then backed up to a tape device at both the local and remote sites.
•
Restoring data using the backup data on the tape device at the local site.
•
Restoring data using the backup data on the tape device at the remote site.
The examples in this section assume the system configuration shown in the following figure.
Application Agent CLI User Guide
431